User manual

8. Commissioning

a) Installing the Steering Servo

Attachtheservoholders(A)tothesteeringservo;observe

the proper arrangement (distance between the screw

holes in the chassis and in the servo holders must match

later!). Suitable screws should be included with your servo.

The servo axis must point towards the middle of the chas-

sis for this.

Putthesteeringservointotheneutralposition(middlepo-

sition)andpushtheservolever(C)ontothedriveaxleof

the steering servo.

Depending on the servo used, a different servo lever may

need to be attached, since the interlock of servo and servo

lever does not match.

Attach the servo lever with a screw on the drive axis of the steering servo, so that the servo lever points up vertically

after installation of the steering servo. A matching screw should be enclosed with your servo.

Insert the steering servo into the vehicle and screw the two servo holders with the attached steering servo into the

associatedopenings(B).Fourrecessed-headscrewsareenclosedwiththevehicle.

b) Installing the Electric Motor

Amatchingelectricmotormustbepurchasedseparately;

it is not part of the delivery.

The motor must be designed for a power supply by 2 LiPo

cells(batteryratedvoltage7.4V)orfor6NiMHcells(rated

voltage 7.2 V).

To install the motor to the motor holding plate, you need to

remove the entire rear axle unit.

Turn the 8 recessed-head screws out from the bottom of

thechassisrst;seecirclemarkinthegureontheright.