User manual

Example:

Set ball-head screw Tighten/loosen plastic grub screw

Set camber more negatively:

Turntheupperball-headedscrew(A)totherightclockwise,andthelowerball-headedscrew(B)totheleftcounter-

clockwise(eachwithasmall2.5mmhexagonwrench(D)).

Set camber more positively:

Turntheupperball-headedscrew(A)totheleftcounter-clockwise,andthelowerball-headedscrew(B)totheright

clockwise(eachwithasmall2.5mmhexagonwrench(D)).

 Twistthetwoball-headscrews(A)and(B)withthesmall2.5mmhexagonwrench(D)inoppositedirections

(!)atalltimesandalwaysbythesameangle(e.g.aquarterturntotheleftorright).

We recommend always changing the setting only by a quarter turn at a time and then reviewing the driving

behaviour. Write down the changes so that you can reverse them again if necessary.

 Thesmallhexagonholeoftheball-headscrews(A)and(B)isonlyvisiblewhenlookingrightthroughthe

largehexagonholeoftheplasticgrubscrews(C).

Do not turn out the ball-head screws too far since the axle stub will no longer stick to the transverse link

otherwise.

Thencheckthatthewheelsuspensioncanbemovedfreely(thewheelcanextendanddeect).Ifthisisnotthe

case,loosentheplasticgrubscrews(C)withthelarge5mm-hexagonwrench(E);forthis,turnitasmallbittothe

left counter-clockwise.

Iftheaxlestubiswobblyatthetransverselinks,turntheplasticgrubscrews(C)intotherightclockwisewiththelarge

5mm-hexagonwrench(E).Donotapplyanyforce,asdescribed,sincethewheelsuspensioncannotmoveotherwise

andthewheelthuscannotextendordeect.

Theballheadscrews(AandB)mustnotbefastenedrmlywiththeplasticgrubscrews(C),butmustbeplay-free.