User manual

The vehicle slows down or the steering servo shows only slight or no reaction; the range between transmitter

and vehicle is very short

• Thedrivebatteryisweakordischarged.

For a speed controller with BEC, the receiver and thus also the steering servo is supplied with power through the

drive battery. Therefore, a weak or discharged drive battery will cause the receiver to no longer work properly. Re-

placethedrivebatterywithanew,fullychargedone(beforeinsertinganewdrivebattery,waitatleast5-10minutes

untilmotorandspeedcontrollerhavecooleddownsufciently).

• Checkthebatteries/rechargeablebatteriesinthetransmitter.

The vehicle doesn't drive in a straight line correctly

• Setstraightdrivingatthetransmitterusingtherespectivetrimmingcontrolforthesteeringfunction.

• Checkthetrackandcambersettingsofthewheels.

• Checkthesteeringrodsortheservoarmanditsscrewconnection.

• Didyourcarhaveanaccident?Ifso,checkthevehicleforanydefectiveorbrokenpartsandreplacethem.

Steering works opposite to the way the turning wheel is turned at the transmitter

• Activatethesteeringreversesettingatthetransmitter.

Driving works opposite to the movement of the throttle/brake lever at the transmitter

• Usually,thevehicleshoulddriveforwardsifyoupullthethrottle/brakeleveratthetransmittertowardsthehandle.

If this is not the case, activate the reverse setting for the driving function at the transmitter.

• Swapthemotorcablestoreversethemotor'sdirection.Forabrushlesselectricmotor,twoofthethreemotorcables

must be swapped.

The steering is not functioning or is functioning incorrectly, steering deection at the vehicle insufcient

• Ifthetransmitteroffersdualratesettings,checkthesesettings(observetransmitter’soperatinginstructions).Ifthe

dual rate setting is too low, the steering servo will no longer react.

• Ifthetransmitterhasan"EPA"setting("EPA"="EndpointAdjustment"),checkthissettingandcorrectitifrequired.

• Checkthesteeringmechanicsforlooseparts;e.g.checkiftheservoarmisproperlyattachedtotheservo.Check

if there may be a small stone that blocks the steering mechanic function.