Instructions

8. Preparations for ying

a) Inserting batteries into the remote control

Removethebatterycompartmentcoveronthebackoftheremotecontrol.Todothis,youmustrstremovethecover

screw and then push the lever in the direction of the arrow. Only then can the battery compartment lid can be lifted off.

Insert four AA/mignon batteries, observing the correct polarity. Observe the polarity markings in the battery compart-

ment. Then replace the battery compartment cover and secure it with the screw.

Figure 1

Operation of the transmitter with rechargeable batteries is not recommended due to the lower cell voltage

(battery = 1.5 V, rechargeable battery = 1.2 V) and the autodischarge of rechargeable batteries. Doing so

would result in a rapid message from the transmitter indicating the low state of charge of the transmitter

power supply.

 Theremotecontrolonlyusesasmallamountofelectricity,thereforedisposablebatterieswilllastforsigni-

cantly longer. We recommend using high-quality alkaline batteries.