User manual

9. Using the transmitter

 Thenumbersusedintheseoperatinginstructionsrefertothegurealongsidethetextorthegureswithin

therespectivesection.Crossreferencestootherguresareindicatedwiththecorrespondinggurenum-

ber.

 Theguresoftheremotecontrolandthemodelintheseoperatinginstructionsareforillustrativepurposes

only. The label, design and colour scheme of the products supplied in series may differ completely from the

guresintheseoperatinginstructions.

a) Inserting the non-rechargeable batteries

The transmitter is supplied by 2 Micro/AAA non-rechargeable batteries.

Important!

Use only non-rechargeable batteries (1.5 V/cell) and do not use rechargeable batteries (1.2 V/cell) as the

power supply for the transmitter.

To insert the non-rechargeable batteries, proceed as follows:

Push the locking latch of the cover lock (1) on the under-

side of the transmitter forward and lift off the battery com-

partment cover (2).

Insert 2 Micro/AAA non-rechargeable batteries (3) accord-

ingtothespecicationsonthebottomofthebatterycom-

partment (4), paying attention to the correct polarity. The

spiral spring contact (5) must always be connected to the

negative pole of the non-rechargeable battery.

Replace the battery compartment cover (2) again and al-

low the lock to snap into place in the transmitter housing.

Figure 2