Instructions

47
10. Programming the speed controller
a) Adjusting the neutral and full throttle setting
If the vehicle does not stay stationary when the throttle/brake lever is in the neutral position, the throttle trim can be
adjustedonthetransmitter.Ifthetrimsettingisinsufcient(orifthetrimisalmostintheendposition),youcanre-
program the neutral and full throttle positions for driving forwards and backwards.
The adjustment functions and values are indicated by the
ashingofthegreenandredLEDsonthespeedcontrol-
ler.
The LEDs can be recognised by the two rear ventilation
openings of the cover, see arrow in the picture on the right.
Thecovercanberemoved to make the ashing of the
LEDs more visible. To do this, unscrew the two screws (A).
Then the cover can be lifted off carefully.
Attention!
The on/off switch with the setup button is
screwed into the cover. Remove the cover
slowly and carefully so as not to damage the
connection cable, loss of warranty/guarantee!
In the picture below, the position of the LEDs is marked
with a circle (B).
Caution!
When unscrewing the cover, make sure that the
cables are not pinched and thereby damaged.
If the cables are damaged, there is a risk of a
shortcircuit-thiscanleadtoareoranexplo-
sion of the batteries!