Instructions

49
b) Programming additional features
By default, the speed controller is preprogrammed with the optimal settings.
When using LiPo rechargeable batteries to operate the vehicle, check whether low voltage protection is
enabled in the default setting of the speed controller (normally 3.0 V per cell). When low voltage detection
is disabled, LiPo rechargeable batteries are subject to a deep discharge that destroys them.
The setup button can be used to program the settings.
Proceed as follows:
• Switch on the remote control.
• Switch off the speed controller (move the switch to the "OFF" position).
• Hold down the setup button (B) next to the on/off switch (A) and turn on the speed controller (move the switch to
the "ON" position).
Keep holding down the setup button (B).
• TheredLEDonthespeedcontrollerwillashandtheenginewillemitbeeps(keepholdingdownthesetupbutton).
• Afterawhile,thegreenLEDwillash(keepholdingdownthesetupbutton)andtheenginewillemitbeeps.This
indicates which setup function is currently selected.
GreenLEDashesoncebrieyandoneshortbeepisemitted:Forward/reversethrottleorforwardthrottleonly
GreenLEDashestwicebrieyandtwoshortbeepsareemitted:Brake
GreenLEDashesbrieythreetimesandthreeshortbeepsareemitted:LowvoltagedetectionfortheLiPobattery
GreenLEDashesbrieyfourtimesandfourshortbeepsareemitted:Startupmode
GreenLEDashesbrieyvetimesandveshortbeepsareemitted:Brakingpower
Beeps are generated by a brief activation of the brushless engine. This beep can be very quiet depending
on the engine. Note the LED indication on the speed controller.
• Whenthedesiredsetupfunctionisdisplayed(forexample,forlowvoltageprotection,thegreenLEDashesbriey
three times and the engine emits three short beeps), release the setup button.
• NowtheredLEDwillash.Thenumberofredashingsignalsindicateswhichsettingvalueisactive(forexample,
for3.0Vpercelllowvoltageprotection,theredLEDashesbrieyfourtimesandtheengineemitsfourshort
beeps).
• Brieypressthesetupbuttontochangethesettingvalue;thenumberofashingsignalsfromtheredLED(and
engine beeps) will change accordingly (see table on the next page).
• Turn off the speed controller to exit settings mode and save the programming. If you then turn on the speed control-
ler, it will be ready for operation with the new settings.
• Follow the above steps to change the other settings.