Instructions

39
9. Setup
a) Open/remove the body
Thebodycanbefoldeduptoengagethedrivebatteryorforadjustmentstothespeedcontrol.Forthispurpose,there
is a special quick lock at the rear of the vehicle.
Do not over-tighten the quick-lock. Do not use force when opening and closing.
Open the body
• Press and hold the round knob (A) in the middle of the
quick lock and turn the outer handle (B) 90° counter-
clockwise (to the left).
• Release the button.
• Thebodycanthenbefoldedupwards.
Close the body
• Fold the body upwards.
• Press and hold the round knob (A) in the middle of the
quick lock and turn the outer handle (B) 90° clockwise
(to the right).
• Release the button.
Set the locking bolt
If the quick lock does not open or close properly, check
that the locking latch (C) has released inside or is twisted.
Thelockingbolt(C)mustbeorientedsothatitisata90°
angle to the handle (B). Only then can the quick lock be
released and closed.
Disassemble the body
Thearticulationbetweenthevehicleandthebodycanbe
very easily removed by unscrewing two screws (D) on the
front of the vehicle (one screw each on the left and right).