Instructions

42
g) Switching on the speed controller
Switch on the speed controller by turning the slide switch
tothe"ON"position.
Thenwaitafewseconds(keepthethrottle/brakeleverin
the neutral position, do not move) until the speed control-
ler has completed its self-test.
If the speed controller has not detected a re-
mote control signal or correct neutral position,
theredLEDwillcontinuetoash.Thespeed
controller cannot be put into operation.
Meaning of acoustic signals LED Status
• 1xshorttone:NiMH/NiCddrivebatterydetected
• 2xshorttones:2-cellLiPodrivebatterydetected
• 1xlongtone:Testwassuccessfullycompleted; the
throttle/brake lever is in the neutral position and the
speed controller is ready for use.
• LEDoff:Throttle/brakeleverontheremotecontrolis
in the neutral position
• LEDashes:Throttle/brakeleverontheremotecon-
trol is in the forwards/backwards position
• LED on: Full throttle forwards
 Theacousticsignalsaregeneratedbytheengine.
Check that the throttle and steering functions are working correctly.