Instructions

50
c) Changing a tyre
Thetyresarexedonthewheelrimandcannotberemoved.Therefore,ifatyreisworn,theentirewheelmustbe
replaced.
After loosening the wheel nut (A), pull the wheel off the
wheelaxle.
Attachthenewwheelsothatthehexsocketontheinside
ofthewheelrimtsexactlyoverthewheelhubnut.
Screwthewheel tight tothewheel axle withthewheel
nut (A) removed at the beginning. Do not apply any force
when tightening the wheel nut, otherwise the wheel will not
spin freely and the powertrain may be damaged.
It may be that the wheel hub nut (B) remains in the rim
when the rear wheel is removed or it comes off the wheel
axle(C).Ensurethatthedrivepin(D)doesnotfalloff.
If the wheel is subsequently re-tted, it is important to
check that the drivepin(D)isinsertedexactlyintothe
centreofthewheelaxle(C)andthatitispositionedinthe
corresponding notch on the wheel hub nut (B).
If the drive pin (D) is missing, no torque can be transferred
from the engine to the wheel and the wheel will spin freely.