Manual
Table Of Contents
- 2 Einführung
- 3 Bestimmungsgemäße Verwendung
- 4 Merkmale und Funktionen
- 5 Lieferumfang
- 6 Neueste Informationen zum Produkt
- 7 Ersatzteile
- 8 Symbolerklärung
- 9 Sicherheitshinweise
- 10 Informationen und Sicherheitshinweise zu Batterien und Akkus
- 11 Bedienelemente und Komponenten
- 12 Flugvorbereitungen
- 13 Flugbetrieb
- 14 Nach dem Flug
- 15 Headless-Modus
- 16 360° Looping
- 17 Austausch der Rotorblätter
- 18 Reinigung und Pflege
- 19 Fehlerbehebung
- 20 Entsorgung
- 21 Konformitätserklärung (DOC)
- 22 Technische Daten
- 2 Introduction
- 3 Intended use
- 4 Features and functions
- 5 Delivery content
- 6 Latest product information
- 7 Spare parts
- 8 Explanation of symbols
- 9 Safety instructions
- 10 Battery information and safety
- 11 Controls
- 12 Getting ready for flight
- 13 Flight operation
- 14 Finished flying
- 15 Headless mode
- 16 360° looping
- 17 Replacing the propellers
- 18 Cleaning and care
- 19 Troubleshooting
- 20 Disposal
- 21 Declaration of Conformity (DOC)
- 22 Technical data
35
Charging:
Connect the USB plug of the charging cable to a USB port of a computer/laptop or a USB charger.
Connect the reverse polarity-protected micro connector of the charging cable to the connection plug of the ight
battery.
Charging starts automatically, and the charging control LED on the USB plug goes on.
When charging is complete and the ight battery is fully charged, the red LED of the USB plug goes out.
Disconnect the charging cable from the ight battery immediately after charging and unplug the USB charging
cable from the computer/laptop or USB charger.
USB charger LED status indicator Explanation
Off Fully charged
On Charging process
12.2 Inserting batteries into the remote control
Always insert a whole set of new batteries into the transmitter. Do not mix full batteries with half-full ones.
Always use batteries of the same type and from the same manufacturer.
1. Use the supplied cross-head screwdriver to open the battery compartment.
2. Then, insert three AAA batteries by following the instructions for the correct polarity inside the battery compart-
ment.
3. Close the cover again.
12.3 Inserting the battery into the drone
Set the switch on the underside of the quadcop-
ter to “OFF”.
Open the battery holder on the underside. Do
this by pressing in the small pin on the back and
sliding the cover away to the rear.