Instructions

19
17. Binding Function
To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are aligned with each other and can be used at once. The binding settings must be renewed
mainly after a replacement of the transmitter or receiver or to remove any interferences.
Before you can bind the receiver to the transmitter, check if the transmitter works in the right digital code (see previ-
ous chapter).
To perform the binding procedure, proceed as follows:
• Transmitter and receiver must be in direct proximity (distance approx. 50 cm).
• Switch off the transmitter.
• Disconnect any servos that may be connected from the receiver.
• Connect the enclosed programming plug (18) to the VCC con-
nection of the receiver.
• The power supply of the receiver (receiver battery or speed
controller with BEC) is connected to the output CH3 of the
receiver.
• Switchonthereceiver.ThereceiverLED(16)startstoash
quickly.
• Pressthebindingbuttonatthetransmitter(seegure2,item
14) and keep the button pressed.
• Switch on the transmitter while the button is pressed. The LED
fortheunder-voltagedisplayashesatthetransmitter.
• WhentheLEDinthereceiver(16)ashesslowlyafterafewseconds,binding,bindinghasbeencompleted.
• Release the binding button at the transmitter.
• Switch off the receiver and transmitter and remove the programming plug.
• Re-connecttheservos/controllerstothereceiver.
• Check the function of the system. If the system is not working properly, perform the process again or check the
digital code of the transmitter; see chapter 16.
 Ifyouhaveswitchedthetransmittertothedigitalcode„AFHDS“andbindan„AFHDS“-encodedreceiver,
theLEDinthereceiverwillnotashslowlybutbelitpermanentlyafterbinding.
Figure 15