User manual

9
10. Setting up the Transmitter
 Inthefurthercourseoftheseinstructions,guresinthetextalwaysrefertotheadjacentgureorthegures
withinthesection.Referencestootherguresareindicatedwiththecorrespondinggurenumber.
a) Inserting the Batteries
Forthepowersupplyofthetransmitteryouwillneed4alkaline
batteries (e.g. Conrad item no. 652507, pack of 4, order 1) of
thesizeAA/mignon.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located at the bottom of the
transmitter. Press the corrugated area (2) and push off the lid
sideways in the direction of the arrow.
Now put the 4 batteries in the battery compartment. Always
make sure the polarity of the batteries is correct. The minus pole
of the battery (3) must be in contact with the spiral spring (4).
A corresponding note (5) is located on the bottom of the battery
compartment.
Once the four batteries have been inserted in the proper pola-
rity, push the battery compartment lid on again and let the latch
catch.
b) Switching on the Transmitter
When new batteries are inserted, switch on the transmitter with
thefunctionswitch(seegure2,item10)fortestpurposes.For
this,slidetheoperatingbuttonfromtheleft(OFF)totheright
(ON).
TheredoperatingcontrolLED(seegure2,item13)islitand
indicatestheon/offstateofyourtransmitter.Thegreenunder-
voltagedisplayLED (also seegure2, item 8)remainslitto
indicatesufcientpowersupplyofthetransmitter.
Ifthesupplyvoltagedropsbelow4,3V,thegreenunder-voltage
LEDstartsashing.Inthiscase,stopoperationofyourmodelas
quickly as possible. Insert new batteries again for further opera-
tion of the transmitter.
Afteryouhaveveriedthecorrectfunctionofyourtransmitter,
switch it off.
Figure 3
Figure 4