User manual

16. Switching the Digital Code

Thetransmitterenablesyoutocontrolreceiverswiththedigitalcode„AFHDS“and„AFHDS2A“.Exworks,thetrans-

mitterissettotheenclosed„AFHDS2A“-encodedreceiver.

IfyouwanttooperateaREELYreceiverwiththedigitalcode„AFHDS“,thetransmittermustbeswitchedrstandthen

the receiver must be bound to the transmitter (see following chapter).

To switch the digital code at the transmitter, proceed as follows.

• Switchoffthetransmitter.

• Movethesteeringwheelforthesteeringfunction(seegure1,item2)toonesidetothestopandkeepitthere.

• Pushandholdthebindingbutton(seegure2,item14).

• Switchonthetransmitterwiththeon/offswitchwiththesteeringwheeldeectedandthebindingbuttonpushed.

• Releasethesteeringwheelandthebindingbutton.

• IfthegreenLEDforundervoltageisashingcontinually,thetransmitterhasswitchedtothedigitalcode„AFHDS“.

 IfthegreenLEDisashingwithinterruptions,thetransmitterhasswitchedtothedigitalcode„AFHDS2A“.

• Pushingthebindingbuttonagainsavesthecurrentlysetdigitalcode.

• Switchthetransmitteroffandthenonagainsothatitsendsinthesetdigitalcode.

Important!

 Thereceiverenclosedwiththeremotecontrolsystem„GT2EVO“workswithcode„AFHDS2A“.Therefore,

always observe that the right code is programmed at the transmitter!