User manual

19
17. Binding Function
To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are aligned with each other and can be used at once. The binding settings must be renewed
mainly after a replacement of the transmitter or receiver or to remove any interferences.
Before you can bind the receiver to the transmitter, check if the transmitter works in the right digital code (see previous
chapter).
To perform the binding procedure, proceed as follows:
• Transmitterandreceivermustbeindirectproximity(distanceapprox.50cm).
• Switchoffthetransmitter.
• Disconnectanyservosthatmaybeconnectedfromthereceiver.
• Connecttheenclosedprogrammingplug(18)totheVCCcon-
nection of the receiver.
• Thepowersupplyofthereceiver(receiverbatteryorspeed
controllerwithBEC)is connectedtotheoutput CH3 ofthe
receiver.
• Switchonthereceiver.ThereceiverLED(16)startstoash
quickly.
• Pressthebindingbuttonatthetransmitter(seegure2,item
14) and keep the button pressed.
• Switchonthetransmitterwhilethebuttonispressed.TheLED
fortheunder-voltagedisplayashesatthetransmitter.
• WhentheLEDinthereceiver(16)ashesslowlyafterafewseconds,binding,bindinghasbeencompleted.
• Releasethebindingbuttonatthetransmitter.
• Switchoffthereceiverandtransmitterandremovetheprogrammingplug.
• Re-connecttheservos/controllerstothereceiver.
• Checkthefunctionofthesystem.Ifthesystemisnotworkingproperly,performtheprocessagainorcheckthe
digitalcodeofthetransmitter;seechapter16.
 Ifyouhaveswitchedthetransmittertothedigitalcode„AFHDS“andbindan„AFHDS“-encodedreceiver,the
LEDinthereceiverwillnotashslowlybutbelitpermanentlyafterbinding.
Figure 15