User manual

g) Switching on

• Leavethethrottle/brakeleveratthetransmitterinitsneutralposition(donottouch/movethelever).

• Switchonthespeedcontroller.

• Waitforafewsecondsuntilthemotoremitsasoundsignal.

The sound signal is generated because the motor is activated for a moment. The sound signal meanings are

listed in chapterr 10.

• Nowcheckthedriveandsteeringfunctionsofthevehicle.

h) Putting on the Car Body and Tail Spoiler and Attaching Them

Push the aerial tube from the bottom of the body through the respective opening. Now put the car body on the holders

in the correct alignment and fasten them with the 2 holding brackets removed at the start.

Remove the two clips for the tail spoiler at the associated holder at the vehicle. Push the tail spoiler onto the holder

and secure it with the two clips.

The charger is now ready for operation.

i) Controlling the Vehicle

Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive too fast at

the beginning until you get used to the car‘s reactions. Do not make any quick and jerky movements with the operating

elements of the remote control.

Never point the transmitter aerial directly onto the vehicle. It will strongly decrease the range. The maximum range will

be achieved when the aerial of the transmitter and vehicle are both vertical and in parallel to each other.

If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly.

When switching between forward and reverse gears, the throttle/brake lever at the transmitter must be put in the

neutralpositionbriey(neutralposition=letgooflever,donotmoveit).Ifthethrottle/brakeleveratthetransmitteris

moved from forward to reverse directly, the brake function of the drive is activated (vehicle will NOT reverse).

Waitforatleast5-10minutesuntilmotorandspeedcontrollerhavecooleddownsufcientlybeforethenextrun.Only

then start a new drive with a full drive battery.