User manual

Proceed as follows to switch on the undervoltage recognition:

• Switchoffthespeedcontroller.

• Thenholdthebutton(seearrowintheguretotheright)

at the speed controller and switch on the speed control-

ler (do not release the button, keep it held down!).

• Whenthemotoremitstwobriefsound signals („• •“),

release the button at once.

Then you will hear three long sounds („- - -“).

• Theundervoltagerecognitionisswitchedon.

If the undervoltage recognition is switched on, the speed controller switches off the motor when the rechar-

geable battery voltage drops below 6.0 V (3.0 V per LiPo cell). This protects the LiPo rechargeable battery

from harmful deep discharge.

Proceed as follows to switch off the undervoltage recognition:

• Switchoffthespeedcontroller.

• Thenholdthebutton(seegureattheupperright)atthespeedcontrollerandswitchonthespeedcontroller(donot

release the button, keep it held down!).

• Whenthemotoremitsabriefsoundsignal(„•“),releasethebuttonatonce.

Then you will hear three long sounds („- - -“).

• Undervoltagerecognitionisdeactivated.

When using am 6-cell NiMH-drive battery, the undervoltage recognition should be deactivated. Otherwise, it

is not possible to use the full battery capacity when driving the vehicle, and the driving time will reduce.

When operating the vehicle with a NiMH battery, stop driving when the vehicle noticeably slows down.

