User manual

Setting Rear Axle Camber:

For setting the camber, twist the screw (1) of the upper

transverse link as for the front axle.

A suitable open-faced spanner can be used for turning (not

enclosed).

Because this screw has a left and right hand thread at

either end, the transverse link does not need to be dis-

mantled for the camber to be adjusted.

Note:

 • Changethesettingsonlygraduallyandthencheckthechangedrunningconducttoseeifitcorresponds

to your expectations. Write down the changes made so that you can easily reverse them again.

 • Twistthescrewsofthetwotransverselinksatthefrontaxleandtherearaxleevenlyatalltimes,since

different settings at the left/right wheel will cause unforeseeable driving behaviour.