User manual

56
The vehicle does not stop when the throttle/brake lever is released
• Correctthedrivingtrimmingonthetransmitter(settingneutralposition).
The vehicle slows down or the steering servo shows only slight or no reaction; the range between transmitter
and vehicle is very short
• Thedrivebatteryisweakordischarged.
The receiver power supply and thus also the power supply of the steering servo is achieved through the speed
controller BEC. Therefore, a weak or discharged drive battery will cause the receiver to no longer work properly.
Replace the drive battery by a fully charged one (before inserting a new drive battery, wait at least 5 - 10 minutes
untilmotorandspeedcontrollerhavecooleddownsufciently.
• Checkthebatteries/rechargeablebatteriesinthetransmitter.
The vehicle doesn‘t drive in a straight line correctly
• Setstraightdrivingatthetransmitterusingtherespectivetrimmingcontrolforthesteeringfunction.
• Checkthesteeringrodsortheservoarmanditsscrewconnection.
• Didyourcarhaveanaccident?Ifso,checkthevehicleforanydefectiveorbrokenpartsandreplacethem.
Steering works opposite to the way the turning wheel is turned at the transmitter
• Activatethesteeringreversesettingatthetransmitter.
Driving works opposite to the movement of the throttle/brake lever at the transmitter
• Usually,thevehicleshoulddriveforwardsifyoupullthethrottle/brakeleveratthetransmittertowardsthehandle.
If this is not the case, activate the reverse setting for the driving function at the transmitter.
• Ifthemotorhasbeendisconnectedfromthespeedcontroller,swapthetwomotorcables.
Thesteeringisnotfunctioningorisfunctioningincorrectly,steeringdeectionatthevehicleinsufcient
• Ifthetransmitteroffersdualratesettings,checkthesesettings(observetransmitter’soperatinginstructions).Ifthe
dual rate setting is too low, the steering servo will no longer react.
• Ifthetransmitterhasasettingfortheendpositionsoftheservodeection(e.g.designated„EPA“,„Endpointadjust-
ment“), check them or correct them.
• Checkthesteeringmechanicsforlooseparts;e.g.checkiftheservoarmisproperlyattachedtotheservo.
The driving time is very short.
• Chargethedrivebatteryoruseadifferent,fullychargeddrivebattery.
• IfanNiMHdrivebatteryisused,switchofftheundervoltagerecognition(seechapter10.b).
The drive battery heats up when charging and driving the vehicle.
• Thisisnormal.