User manual

 Instuctions
1. Connect BEC wires with the receiver
2. Connect motor wires with ESC
3. Turn on the transmitter
4. Connect battery pack with ESC then switch on the ESC.
5. When the connection of motor and battery is finished, the motor emits “Beep-Beep” tone.
6. When the throttle stick is in the neutral position, the motor re-emits “Beep-Beep” tone.
7. The ESC is workable.
 Program Method
1. Connect BEC wires with the programmer then turn on the ESC.（80A、120A press the keys to be not
put）
2. The Green LED flashes for 2 times then LED off, that is, the connecting programmer with ESC is
successful, and the Red LED on presents the current value of that item. Otherwise, the connecting is
failed.
3. Please press the Key “↓” to select different programs
4. Please press the Key “→” to select different value of the current program
5. Please press the Key “Program” to confirm above selections, the Green LED on immediately and has
gone out within 5 seconds, that is, this process is successful.
6. Please press the Key “Reset” to reset the factory setting.
 Troubleshooting
1. If after power on, motor can’t work, no sound is emitted, please check the connections between
battery pack and motor.
2. If after power on, LED flashes, please check the voltage of battery pack, which should be from
5V~13V.
3. If the motor emits a “Beep-Beep” tone Only, please check all the connections: BEC wires, transmitter and receiver,
throttle signal wires, etc.
4. If the car can’t be speed up, please check either voltage of the battery pack is too low or the
temperature of ESC is too high. If the voltage of the battery pack is too low, please replace the battery
pack. If the temperature of ESC is too high, please check all connections.
5. If the car stops suddenly while in working state, please check the motor’s connections, and the
roadblock.
6. If the car runs in the opposite direction, which the transmitter is available, please swap two wire
connections between the ESC and the motor.