Installation Guide

Installation Instructions
Toyota Tundra
Part Numbers:
51047
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 7/8, 18mm
Drill Bits: None
1
1. Insert carriage bolt and block in rearmost attachment holes on each frame rail as shown above.
2. Raise hitch into position and loosely attach hex nuts and conical washers to carriage bolts.
3. Install remaining M12 fasteners as shown above.
Rev. B10-16-09N51047Sheet 1 of 1
z 2001, 2002, 2006, 2009 Cequent Performance Products
Conical Washer 1/2Qty. (6)
3
Hex Bolt M12 X 1.25 X 35Qty. (4)
5
BlockQty. (2)
2
Hex Nut 1/2-13Qty. (2)
4
Carriage Bolt 1/2-13 X 1.75Qty. (2)
1
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: K51047
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 (227 Kg)5000 (2270 Kg)
Weight Carrying
Ball Mount
750 (341 Kg)7500 (3405 Kg)
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PU3
Form: F205 Rev A 5-6-05
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Existing weldnuts
Rivet clearance hole
Frame rail
Note: Fasteners typical both sides
5
3
3
4
5
2
Step bumper