Installation Guide

3
1
2
Installation Instructions
Nissan Titan
Part Numbers:
51106
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 19mm
Drill Bits: None
1. Remove tow hook if present and return to owner.
2. Raise hitch into position, aligning holes in hitch with the existing weld nuts in vehicle’s frame rail.
3. Install M12 hex bolt, lock washer and flat washer as shown (hand tighten only until all fasteners are installed).
Rev. A7-24-0951106NSheet 1 of 3
z 2009 Cequent Performance Products
Lock washer 1/2”Qty. (6)
2
Flat washer 1/2”Qty. (6)
3
Hex bolt M12 x 1.25 x 45mm CL8.8Qty. (6)
1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Fastener Kit: 51106F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
600 (272 Kg)6,000 (2724 Kg)
Weight Carrying
Ball Mount
1,000 (454 Kg)10,000 (4540 Kg)
Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PU3
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Fascia
FASTENERS TYPICAL BOTH SIDES OF VEHICLE
Tow hook