Owners manual

ManualsBrandsReese ManualsAutomotive58023 Custom Bracket Kit For Universal Fifth Wheel Rail Kit

CAUTION:

Check for obstructions before drilling. Failure to do so could result in damaged fuel or

brake lines, structural members, etc. TOWING PRODUCTS does its best to communicate

tow vehicle manufacturer changes; however, it is ultimately the responsibility of the

installer to prevent damage due to installation.

DODGE ‘02 AND NEWER 1500 (58023 KIT - OPTIONAL)

26 5/16” Short Bed

28 5/16” Long Bed

Side Bracket

Front

Vehicle

Rear Edge of

Truck Bed

* Optional weld

pattern

Drivers side of 1500 Ram Long box Shown

King Pin Centered

over Axle Center

1/4 1.5-3

1/4 2

Use provided tube spacer and 4 1/2”

carriage bolt to attach through Bed

Sill

Forward

access hole

Rearward access hole (in bottom of frame)

Measure from Rear Edge of truck

bed to rear edge of base rail.

Long bracket

CAUTION!

Read Installation Guide (page 10-11) before starting installation. Failure to do so could result

in significant vehicle damage!

Short bracket (driver’s side) outside frame

ROW 1

ROW 2

ROW 3

ROW 4

Dodge custom mount bracket

(Passenger Side Only) (Kit # 58023)

Dodge Custom Mount

Bracket - Passenger

Side Only (Kit # 58023)

Bed Sill

IMPORTANT NOTES FOR THIS INSTALLATION:

1. Tube spacer and 4 1/2” carriage bolt used to attach through rearward Bed Sill (Row 3).

2. **Rib neck bolts will need to be pulled through access holes in frame with supplied pull wire (see below).

3. Do not drill

thru both walls of

frame. Drill only

thru wall of frame

to which bracket

is mounted.

4. It is very

important that

brackets in Row

2 are against

rear side of Bed

Sill as shown

below.

5. Due to

dimensional

instability in Bed

Sill placement

with the Dodge

truck,

interferences

could result when

drilling in Row 3.

Observe caution

note below and

double check all

areas prior to

drilling.

Drill through

Bed Sill with

17/32” drill.

Open up hole

through truck

bed only with

1” dia. drill.

Drop tube

spacer through

hole in truck

bed to avoid

crushing Bed

Sill when

torquing 4 1/2”

carriage bolt.