Installation Guide

Models With
OEM Tow Hooks
Models Without
OEM Tow Hooks
Drilled Hole
Drilled Hole
Frame Rail
Existing
Access Hole
Tow Hook
Receiver Shown In Proper Position
Fascia
Front Mounted Receiver
Installation Instructions
Chevrolet Silverado Pickup, Suburban 1500 2 & 4WD, Tahoe 1500 2 & 4WD;
GMC Sierra Pickup, Yukon, & Yukon XL 1500 2 & 4WD
(Vehicles With Amber Turn Signals)
WILL NOT FIT 2500 SERIES
Part Numbers:
65023
NOTE: On most 2006 Suburban and Yukon models, air dam must be trimmed. CONSULT VEHICLE OWNER BEFORE TRIMMING.
1. Remove the two (2) M12 fasteners from frame rails (for vehicles equipped with factory tow hooks).
2. Place hitch into position. For those models with OEM tow hooks secure with the provided M12 fasteners and washers. For models without
tow hooks secure hitch with 1/2” fasteners, washers and handle nuts.
3. Using hitch as template drill two (2) 1/2" holes in frame rails.
4. Install remaining fasteners as shown.
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Rev. A10-31-05N65023Sheet 1 of 3
z 2005 Cequent Towing Products
Hex Bolt, M12 x 1.25 x 35Qty. (2)
4
Conical Washer, 1/2”Qty. (4)
2
Handle Nut, 1/2”Qty. (4)
3
Hex Bolt, 1/2”-13 x 1-3/4”Qty. (4)
1
Tighten all 1/2” GR5 fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL
9000
Equipment Required:
Wrenches: 3/4”, 18mm
Drill Bits: 1/2”
Fastener Kit: 01131-133