Installation Guide

Installation Instructions
Chevrolet Aveo Sedan
Part Numbers:
24810
60896
77181
Hitch Shown In Proper Position
Wiring Access Location: PC3, 4
Equipment Required: Sealant
Wrenches: 3/4”, Crowfoot adaptor
1
2
2
Fascia
1. Remove trunk panel to gain access to end panel. Remove spare tire cover.
2. Remove (2) trunk rubber plugs located in the end panel. Return to owner.
3. Place carriage bolt and spacers (2) onto tow hook. As shown Figure 1.
4. Raise hitch into position behind end panel and fasten to tow hook with conical washer and hex nut. Hand tighten.
5. Install fasteners on drivers side. Place spacer (Item 2) inside trunk add sealant around hole. Install fastener as
shown in Figure 1 or optional Figure 2. Hand tighten to prevent hitch from moving while installing passenger side.
6. Install fastener on passenger side. Once again adding sealant around hole. Install fasteners as shown in Figure 1
or optional Figure 2 .
7. Tighten all fasteners to specification listed below.
8. Apply sealant at bolt attachments inside spare tire well to prevent the intrusion of water and exhaust fumes to
vehicle interior.
9. Reinstall trunk panel. Reinstall spare tire cover
Rev. A3-7-0824810NSheet 1 of 3
z 2008 Cequent Towing Products
½” Pull wireQty. (1)
6
Conical washerQty. (3)
3
Carriage bolt ½-13 x 2.00 GR5Qty. (2)
5
SpacerQty. (4)
2
Hex nut ½-13Qty. (3)
4
Carriage bolt ½-13 x 2.25 GR5Qty. (1)
1
Tighten all ½” Gr5 fasteners with torque wrench to 75 Lb.-Ft. ( 102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE
position only.
Drawbar Kit:
3593
Fastener Kit: 24810F
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (91 Kg) Max Tongue Weight
Impact bar
3
4
4
2
3
4
5
5
2
34
43
Bar
Bar
Bar
End panel
End panel
End panel
Inside
trunk
Inside
trunk
Optional trunk
fasteners assembly
Spacers (item 2)
must be inside of
trunk.
Seal existing drain holes
in trunk pan to prevent
intrusion of exhaust
fumes and water.
Tow hook
Remove
rubber
plugs
Tow hook
Figure 1.
Figure 2.
2
Optional fasteners assembly.
Form F206 Rev A 5605