Installation Guide

Recommended Products:

Reflective/Bubble/Bubble/Reflective - Roll: BP24025 (24”x 25’), BP48025 (48”x 25’)

Staple Tab, Reflective/Bubble/Bubble/Reflective - Roll: ST16025 (16”x 25’)

Installation Instructions:

• Inspect the crawl space and make any needed repairs before installing Reflectix

Reflective/Bubble

product.

• For floor joists that are 16” on-center, the installation is easiest with the Reflectix

Staple Tab (ST)

product.

• Determine if there are water pipes and heating ducts which hang below the floor joists. They will

need to be insulated. Reflectix

Pipe Wrap and Duct Insulations are designed specifically for this use.

There is no need to wrap water pipes or duct work that fall between floor joists. Reflectix

will

provide adequate insulating without extra wrapping.

• Begin at one end of the house and staple the first course of product to the top of the band board or

the subfloor (also terminating this course in this fashion).

1. Reflectix

Insulation

2. Concrete Block

3. Band Board

4. Sub-Floor

5. Floor Joist

Tools Required:

Safety Glasses

Staple Gun

Tape Measure

Utility Knife/Scissors

Crawl Space| (R-21)

Reflectix

Installation Instructions