Installation Guide

Review These Important Safety Guidelines Prior to Installation:
• A
LWAYS
c
heck local building codes before installing Reflectix
®
.
• ALWAYS check the area you are insulating and make any needed repairs. Any worn wiring should be replaced before you begin installing Reflectix
®
.
• ALWAYS make sure work areas are well ventilated and well lighted.
• ALWAYS use eye protection when operating a staple gun.
• ALWAYS use caution and common sense when using a staple gun. Be aware of where electrical wiring is located. Stapling into a wire can cause
severe shock or death. NEVER staple into electrical wiring.
• ALWAYS be careful when working with large pieces of Reflectix
®
on windy days.
• When installing Reflectix
®
on bright sunny days, it is best to wear sun glasses.
• Do not work in areas such as attics when temperatures are too hot.
• Visit our website at www.reflectixinc.com for additional product and installation information.
Please Note:
The intention of these Installation Instructions and 3-D renderings are for the sole purpose of illustrating the correct location and relative position of the
Reflectix
®
products in specific building assemblies. The correct construction methods and techniques are the responsibility of the installer or contractor.
The methods outlined are recommendations on location of the Reflectix
®
products as a guideline. There are no claims on the part of Reflectix, Inc. that
these building assemblies are finite standards or meet building code requirements (as they can vary by region).