Installation Guide

Recommended Products:

Staple Tab, Reflective/Bubble/Bubble/Reflective - Roll: ST48100 (48”x 100’)

Open Interior

R-4.5* Heat Flow Horizontal

Installation Instructions:

• Install 1”x 2” furring strips on the inside and perpendicular to the Z girts on 22” centers. Utilize

1 1/4” self-tapping sheet metal screws to secure the furring strips to the Z girts.

• Butt the furring strips together and tape. Staple tape for reinforcement.

• Attach the product using 5/16” staples at approximately 4” intervals.

• Staple the edges of the Reflectix

Reflective/Bubble/Bubble/Reflective, Staple Tab product to the

furring strips with the 3/4” tabs (so that they will overlap at the seam).

• Tape the seams with a Reflectix

Foil Tape (goal is an air-tight, snug seam seal).

• Staple product down the middle of the sheet into the furring strip parallel and centered.

1. Reflectix

Insulation

2. Exterior Wall Panel

3. Girt

4. 1”x 2” (Nominal)

Furring Strip

5. Red Metal (Structural

Frame)

Tools Required:

Safety Glasses

Tape Measure

Utility Knife

Screw Gun

Staple Gun

Metal Building / Wall / Retrofit

Reflectix

Installation Instructions