Manual

EN
60
Add satellite:
Satellite Name: Edit the name of the satellite.
Longitude Direction: East / West
Longitude Angle: Enter a new longitude angle.
Band: Ku / C
Add transponder:
Frequency: Enter a new
frequency.
Symbol (ks/s): Enter a new symbol
rate.
Polarity: H (Horizontal) / V
(Vertical)Search
[Blau]:
1. Use the [▲ ▼ ◄►] buttons to select a satellite
or transponder that you want to scan.
2. Press the [OK] key to mark the satellite or transponder.
3. A red rake marks the selection.
4. Now press the [Blue] key to open the search settings.
5. Press [OK] when all the settings have been made to start the search.
6. The following setting options are available:
Scan Mode: Default / Network / FastScan
Channel Type: All Channels / FTA Channels
Service Type: All / DTV / Radio
Note:
 The found channels are appended to the list.
LNB SETTINGS
The LNB settings on the right side of the menu
usually do not need to be changed and are only
required for multi-switch configurations or if a
motorized SAT system is used without its own
control unit. The following setting options should
only be changed by experienced persons or by
qualified personnel.
1. Navigate in the menu with the [▲ ▼]
buttons.
2. Use the [◄►] button to adjust the settings.
3. Use the [OK] key to confirm the entry.
4. Press the [MENU] key to return to the
previous menu.
5. Use the [EXIT] key to close the menu display.
6. The following selection and setting options are available in the menu:
LNB Type: 9750/10600, 9750/10750, 5150/5750, 05150, 05750,
09750, 10600, 10750, 11300, 11475, User Single, User Dual,
Unicable
LNB Power: 13/18V, 13V, 18V, Aus
22KHz: Auto, Off, On