SDS

Keep container tightly closed and in a well-ventilated place. Use local and general ventilation. Keep cool. Protect from
sunlight.
Keep away from sources of ignition - No smoking. Keep away from heat, hot surfaces, sparks, open flames and other igni-
tion sources. No smoking. Take precautionary measures against static discharge. Protect from sunlight.
Heat, High temperatures, Frost
Use local and general ventilation. Ground/bond container and receiving equipment.
Only packagings which are approved (e.g. acc. to ADR) may be used.
See section 16 for a general overview.
General ventilation.
Wear eye/face protection.
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-
tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off and air
them well. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves men-
tioned above together with the supplier of these gloves.
- Explosive atmospheres
- Flammability hazards
Control of the effects
Protect against external exposure, such as
- Ventilation requirements
- Packaging compatibilities
7.3 Specific end use(s)
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limit values (Workplace Exposure Limits)
Country CAS No Identifier TWA [ppm] TWA [mg/m³] STEL [ppm] STEL [mg/m³]
US 34590-94-8 PEL 100 600
Notation
STEL short-term exposure limit: a limit value above which exposure should not occur and which is related to a 15-minute period unless
otherwise specified
TWA time-weighted average (long-term exposure limit): measured or calculated in relation to a reference period of 8 hours time-weighted
average
8.2 Exposure controls
Appropriate engineering controls
Individual protection measures (personal protective equipment)
Eye/face protection
Skin protection
- Hand protection
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
Version number: 1.0 Date of compilation: 2015-12-16
United States: en
HS 286 SDS-01:
Page: 5 / 10