User Manual

4
Safety and warranty
• Do not use this unit near liquids, or expose to moisture.
• Do not use near sources of heat such as radiators, vents, stoves, or candles.
• Ensure adequate ventilation around the product, at least 10 cm in all directions, and avoid placing the unit on soft surfaces
such as long carpet and fabric.
• Do not open the product enclosure or force objects into openings in the unit.
• 
• The unit should only be used in moderate climates between 5 °C (41 °F) and 35 °C (95 °F).
• 
• 


• All Rega products are covered by a lifetime warranty against manufacture defects.
• This warranty does not cover wear and tear.
• 
• If returning goods for inspection to your retailer, the original packaging must be used to preserve warranty.
• Replacement packaging is available from any Rega retailer.
• Your statutory rights are not affected.
Neo specications
Output to motor bi-phase = 24 V AC protected by resettable fuse.
Power consumption = 7.2 W



The basic one bar per minute drift resolution = 0.016%

Input 230 V ~ 50 Hz 0.07 A
Output 24 V ~ 350 mA AC

Input 230 V ~ 50 Hz 0.07 A
Output 24 V ~ 350 mA AC

Input 115-120 V ~ 60 Hz
Output 24 V ~ 350 mA AC
Warnings
• Do not unplug the power supply from the turntable whilst the unit is on - turn off the power supply before unplugging.
• Do not operate the power supply without the turntable connected.
• A 24 V AC plus a 20 V DC signal present on the pins of the plug - if these are shorted it will cause damage to the power unit.
• 
• Do not open the case covers. There are no user serviceable parts inside.

run erratically or not at all. If in the rare circumstance these are activated, they are reset by turning off the Neo via the front panel
for approximately 10 seconds. If the fault should persist, consult your dealer.
PS1 (Australian)
Input 230 V ~ 50 Hz 0.07 A
Output 24 V ~ 350 mA AC
PS1 (Japan)
Input 100 V ~ 50/60 Hz
Output 24 V ~ 350 mA AC

Input 220 V ~ 60 Hz 0.07 A
Output 24 V ~ 350 mA AC