Installation Guide

4. Install the light bulb – Type A19 or G25, 60 Watt Max. CFL bulbs may be used.

5. Remove the mounting bracket assembly from the canopy and install mounting

bracket to existing outlet box with outlet box screws provided.

6. Make the electrical connections (Required Supply Circuit: 120V 60Hz):

a. Connect the neutral/white wire from the fixture to the neutral/white wire from the

Outlet Box.

b. Connect the live/black wire from the fixture to the live/black wire from the Outlet

Box.

c. Connect the ground wire from the fixture to the ground wire from the Outlet Box.

d. Secure the connections using the wire connectors. Wrap the wire connections with

electrical tape to secure the connections.

e. Place the wires back inside the outlet box.

7. Secure the canopy to the mounting bracket with the screws provided.

RELAMPING THE LIGHT BULB(S)

1. Turn off the power to the light fixture.

2. Remove the old light bulb(s) and install the new light bulb(s).

3. Restore power to the light fixture.

CAUTION: Refer to the re-lamping label located on the fixture. Do not exceed

recommended wattage.

ASSEMBLY DIAGRAM

Outlet

box

2. Wire connector

3. Ground (bare) wire

4. Neutral (White) wire

5. Live (Black) wire

6. Ground screw

7. Mounting bracket

8. Outlet box screw

9. Canopy screw

10. Fixture body

11. Large glass shade

12. Retaining ring

13. Socket ring

14. Small glass shade

15. Bulb(sold separately)