Owner`s manual

55
Systems
Typical Dockside Pump-Out
There is a fi tting located on the deck
labeled “waste.” This fi tting is used
to pump out the waste tank. Nor-
mally a pump out station is found
at most marinas. After removing
the fi tting cover a special hose is inserted into the fi tting
and the machine then removes the waste. Normally there
is a charge for the service. Make sure they connect the
hose to the “waste” fi tting. Of course when cruising in
international waters the overboard discharge pump may
be used. See the section on using the macerator.
There is a holding (waste) fi lter installed in the vent line
between the waste tank and the port thru-hull fi tting. See
photo above. The fi lter’s purpose is to keep objectionable
odors to a minimum from the waste tank. It is recom-
mended that the fi lter be changed yearly. It can be ordered
from your Regal dealer or from marine supply stores.
Typically the waste fi lter is mounted on the bulkhead aft
of the galley sink area. The fi lter is designed with a union
at each end for easier removal.
Holding Tank Vent Line Filter