Owner`s manual

8
REMOTE CONTROL
GENERAL INFORMATION
Multiple code choices are included with your fan’s remote control in case:
• you have more than one remote control fan and want them to respond only to their own remote control
• you have other radio controlled devices in your home that may interfere with the fan remote control (i.e. garage
door opener)
• you experience radio interference on a chosen frequency (code setting)
NOTE: Factory code settings should not be used.
SET-UP AND OPERATING INSTRUCTIONS
Setting the code:
This unit has 16 different code combinations. To set the code, perform these steps:
1. Setting the code on the TRANSMITTER [Fig. 1]:
a.
Remove battery cover.
b. Slide code switches to your choice of ON or OFF position. Use a small screwdriver or ball point pen to slide
each switch firmly up or down.
c. Install 9v battery (not included).
d. Replace battery cover on transmitter.
2. Setting the code on the RECEIVER [Fig. 2]:
a. Locate the code switches on the top of the r
emote r
eceiver under rubber seal cover.
b. Slide code switches to the SAME POSITIONS as set on your transmitter.
c. Reinstall seal cover.
After codes ar
e set:
1. Install the receiver in the space above the ball
in the hanger bracket [Fig. 3]. Be careful not
to pinch any of the receiver’s wires.
2.
Slide canopy up and secur
e with set scr
ews
in hanger bracket.
1234
1234
ON
Code
TRANSMITTER
ON ECE
Switches
Code
RECEIVER
1234
ON
1234
ON DIP
Antenna
Switches
Fig. 2
Hanger
Ball
Receiver
bracket
Fig. 3
Fig. 1