Owner`s manual

ELECTRICAL CONNECTIONS (REMOTE CONTROL)
GENERAL INFORMATION
This remote control is designed to separately control your ceiling fan speed and light brightness. There are four but-
tons (hi, medium, low, off) to control the fan speed and off. The light dimmer button will control the light brightness
dimmer and off. The red indicator on the transmitter will light when the button is pressed.
INFORMATION AND OPERATING INSTRUCTIONS
1. Setting the code:
This unit has 16 different code combinations. To set
the code, perform these steps:
A. Setting the code on the TRANSMITTER:
a. Remove battery cover. Press firmly below
arrow and slide battery cover off.
b. Slide code switches to your choice of ON or
OFF position. Use a small screwdriver or
ball point pen to slide each switch firmly up or down. (Fig. 1)
B. Setting the code on the RECEIVER:
a. Slide code switches to the SAME POSITIONS as set on your transmitter. (Fig. 2)
b. Replace battery cover on transmitter.
2. Installing Receiver in Mounting Bracket:
A. Safety precautions:
• Warning: High Voltage: Disconnect source of electrical power by removing fuse or switching off circuit
breaker.
B. Electrical connections:
• Make connections as follows, using the wire nuts supplied (Fig. 3).
Connect GREEN ground wire to BARE (ground) wire.
Connect BLACK control unit wire to BLACK supply wire.
Connect WHITE control unit wire to WHITE supply wire.
Connect WHITE control unit wire (MOTOR N) to WHITE fan wire.
Connect BLACK control unit wire (MOTOR L) to BLACK fan wire.
Connect BLUE control unit wire (for LIGHT) to BLUE fan wire.
If wir
es are different in color,
or you do not feel confident
in wiring your fan yourself,
have this unit installed by a
qualified licensed electrician.
9