Owner`s manual

INSTALLING THE FAN
ATTACHING DOWNROD, CANOPY AND COLLAR COVER (FIG. 4):
1. Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin;
remove ball.
2. Feed the 3 wires from top of fan through either end of downrod and set end of downrod into mounting collar.
3. Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of
downrod pin to hold downrod pin in place.
4. Tighten security screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod.
NOTE: Fan has 6 feet of hook-up wire in case you are using an extension downrod. Wires can be cut so only 8 inches
or so extend beyond the top of the downrod to make the electrical connections easier and safer.
5. Feed wires through collar cover and slide collar cover over downrod to top of fan. Rubber grommet on collar
cover will hold it in place.
6. Feed wires through canopy and slide canopy over downrod to lay on top of collar cover. It will be attached to
ceiling later.
7. Feed wires through ball and slide ball over downrod, past hole in end of downrod. Insert ball pin (removed in
Step 1), slide ball up and tighten ball’s set screw to secure ball in place.
6