Installation manual

14
Regency Bellavista™ B36XT Gas Fireplace
INSTALLATION
FINISHING
Non-combustible
Material
J-style Trim
or metal corner bead
may be used to finish these
edges
Non-combustible
Material
Non-combustible
Material
Diagram 2
Diagram 1
IMPORTANT FINISHING DETAIL NOTE:
Before placing unit into fi nal position - it is important to know the total
thickness / height of fi nished hearth (tile, carpet, etc.) The base of the
fi replace should be level or higher than the fi nished hearth height.
Diagram 3 Shown with optional fi nishing trim
Finishing material - thicker
than 1-1/4"
Important:
Finishing materials such as tile, river rock, etc, must not protrude
beyond the front facing fl anges the sides and top of the fi rebox
opening.
Full Screen Doors Only:
If fi nishing with any material thicker than 1-1/4" - a 3/4" gap must
be maintained between the full screen doors and the fi nishing
material.
This gap is necessary to facilitate the installation and removal of the
full screen doors.
Note: All non-combustible facing material should butt up cleanly
to the fl anges around the fi rebox opening.
Rough edges will be visible from the front view with the fl ush
louvers or fl ush panels - if not using the optional fi nishing trim.
To maintain a clean fi nished edge - it is recommended to install
the non-combustible facing material with the fi nished edge
against the fi replace / nailing strips.
Alternatively, you can use J Style Trim or Metal Corner Bead
to cover cut edges of the non-combustible facing material.
Diagram 5
Diagram 4
Full Screen
Door
3/4"
40
1
2
"
35
3 4
"
Note: Full Screen Door Dimensions - page 6.