Owner`s manual

NOTE: Be sure to turn of the power before installing.

1. If installing a light kit, attach to switch housing per instructions supplied with light kit. See “Electrical

Connections” for hook-up of light kit. Carefully remove kit plug in bottom of switch housing.

2. If not already installed, install detachable switch housing mounting hub. Remove only one screw and

loosen the other two only. Install detachable switch housing mounting hub and re-install screw. Tighten all

three screws once loose screw is re-installed.

3. If installing all optional light kit, remove disc type plug threaded into switch housing. Install fixture to

switch housing and wire fixture to fan wire.

4. Attach the switch housing to the detachable switch housing mounting hub by first removing one of the

four mounting screws. Loosen the other 3 screws so housing will fit behind the screw heads. Align holes in

switch housing with mounting hub screws.

5. Insert side screw that was removed and tighten all four screws.

6. Turn the power on. Your fan is ready for operation.

INSTALLATION OF DETACHABLE SWITCH HOUSING

Detachable

Switch Housing Hub

Side Screw (4)

Switch Housing

Side Screw Holes

Optional Light Kit

screws into bottom

of Switch Housing

Side Screw Holes

Black

White