Owner`s manual

Be sure electricity is turned off at the main power box before wiring.*
Five wires are connected to the fan
Black - the “hot” power to run fan.
White - the “common” power to run fan and light,
also referred to as “AC neutral”.
Blue - power for light.
Orange - power for uplighting
Green - ground wire.
Six wires are connected to the remote control receiver.
Four will connect to the four wires coming out of the fan
(matching color to color) and the remaining black wire and
white wire will connect to the building AC circuit, ground
to ground.
BE SURE ELECTRICITY IS TURNED OFF AT THE
MAIN POWER BOX BEFORE WIRING.
Connect six power wires as shown [Fig. 1], using wire nuts
provided. Connect green ground wire to building ground
wire circuit. Extend antenna wire inside canopy, but do not
attach to any other wir
e.
NOTE: If power to the fan’s electrical ceiling box is
controlled by a wall switch, the wall switch must r
emain
ON for the radio remote control to operate. Turning the wall
switch OFF will turn off all fan/light functions and resets
the receiver back to default mode. The wall switch will need
to be tur
ned back ON to allow use of remote control.
* Restor
e power by r
eplacing fuse or r
esetting cir
cuit breaker
ONL
Y AFTER ALL INST
ALLA
TION AND ELECTRICAL
WORK IS COMPLETED AND DOUBLE-CHECKED.
8
ELECTRICAL CONNECTIONS
*
Fan and light controlled by
independent wall switches.
Light
switch
FAN
switch
RED
BLK
WH
BLUE
Wiring Box
BLK
BLK
WH
WH
WH
WH
BLUE
BLK
FAN
LIGHT
Power Lines
120V
Green
ground
Ground to
downrod on mounting bracket
BLK
BLK
WH
WH
WH
WH
BLUE
BLK
LIGHT
120V
Green
ground
Ground wire
BLUE
BLK
WH
ORANGE
Fig. 1