Installation manual

LRI4E / HRI4E Direct Vent Gas Insert | 35
|
35
installation
BACKING PLATE INSTALLATION
919-419
09.23.14
1
BACKING PLATE INSTALLATION
1. Install the rear faceplate and secure with 6 screws as shown.
Route power cord through the inner and outer rear profile of the
rear faceplate on the right side. Install grommet and wire clip.
2. Install the supplied screw into the rear faceplate through the
center hole of the hanger as shown below.
4. Line up the notch in the center of the spacer and backing plate com-
bined with the protruding screw installed in Step 2.
If just installing backing plate - line up the backing plate with this
screw.
3. If installing the spacer, accent trim, secure backing plate to spacer,
accent trim with 7 screws in locations shown below. Painted side of
backing plate faces spacer accent trim.
5. Slide the spacer and backing plate (or just backing plate if no spacer
is required) down gently, once in position, secure in place with 4
screws in the locations shown below.
Center Hole
Power cord
5. Install the Vignette Faceplate by hooking the mounting ange over
the hanger as shown.
See Vingette Faceplate Installation Instructions
NOTE: To access remote receiver pull the bottom of the faceplate
towards you. It is located in the bottom left corner.