Installation manual

L390E-2 / HZI390E-2 Direct Vent Gas Insert
31
INSTALLATION
BRICK PANEL INSTALLATION
Brick panels are soft and fragile. Use caution when handling the panels,
being careful not to jar them or scratch the painted surfaces.
1) Remove left/right filler sections and discard - see below.
5) Once one Firebox Liner Side is installed, you can release the Firebox
Liner Rear. The side Liner will hold the rear Liner in place. Install the Fire-
box Liner Left the same way you installed the Firebox Liner Right. Both
side liners should be just slightly back from the front edge of the Firebox.
Firebox Liner Left
Firebox Liner Right
Firebox Liner Rear
Firebox Liner Retainers
Firebox Liners
U
pp
er Left of Firebox
Exhaust Baffle
Firebox Liner Left
Lower Right of Firebox
Firebox Liner
Retainer (x2)
Firebox Liner Right
Left /right filler sections
2) Remove the firebox liners from their packaging. Inspect them prior to
installation to make sure they haven`t been damaged during shipping.
3) Install the rear brick panel, by placing it against the rear of the firebox.
The bottom of the brick panel rests on a small sheet metal lip, just above
the air intake at the bottom rear of the Firebox. You will need to hold this
panel in place while you install the right brick panel. Do not let go of the
panel or it may fall forward and be damaged.
4) While holding the rear brick panel in place, slide the right along the side
of the firebox toward the rear of the firebox. Each side Firebox Liner will
sit upon a Firebox Liner Retainer and the top will be held between the
Exhaust Baffle and the side of the firebox.
'LDJUDP
/(%VKRZQ
Brick Panel Installation