User`s manual

User's Manual Page 9
Section 3.
Using Your Model 4720 Security System
The following is an operating guide for each of your Model 4720 security
system functions or capabilities. Go over each with your installer if you
have any questions, and practice them until you feel comfortable with the
day-to-day operation of each function.
Arming Your System
When leaving your office or business you will want to arm the intrusion
protection of your security system as follows:
1. Make sure the green READY light is lit, and the ARMED light is off.
2. Enter your access code (3 to 6 digits) on the touchpad.
Note: You have a 3-second timeframe to enter each digit of your access
code. If you pause for 3 seconds, you will hear a short beep and the
touchpad display will tell you to TRY AGAIN.
If make a mistake entering your code, you can also press the CLR
button and start over again.
When you finish, the green READY light will go off, the red ARMED light
will come on, and your system will be armed.
The LCD will show the seconds remaining until the exit time expires. (You
and your alarm company will have determined the exact number of seconds
necessary.) The touchpad may give you an exit warning tone with beeps to
count down your exit time for you. You must be out of the building with the
door shut before the time runs out or an alarm will sound.
If the touchpad shows a TROUBLE condition when you attempt to arm the
system, contact your central station for servicing immediately. DO NOT
attempt to arm the system until the TROUBLE condition is cleared as your
system will not be fully operational.
Disarming Your System
To disarm, simply enter your access code (3 to 6 digits) on the touchpad.
When you return and open a building door on the delay circuit, an entry
warning tone will sound and you will have a programmed amount of time to
enter and disarm the system.
Technical Manuals Online! - http://www.tech-man.com