Installation manual

Regency
®
Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98
9
3.4.2 Touchpad Operation
The Model 4734 Access Expander provides the following additional touchpad functions:
3.5 Dumping Event Memory to Central Station
The 4734's event memory can be transmitted to the central station to be saved as a permanent
record. Currently, this must be done using the Model 5540 Downloading Software.
The 4734's event memory can be uploaded using a procedure similar to the one used to upload
programmed options. The procedure is explained in Section 6.3 of this manual.
Table 3: Touchpad Functions
DOOR ACCESS
To gain access at a card reader or touchpad at a controlled access door,
just present the card or
press DOOR and enter the PIN at the touchpad.
To open a door at another station, press the number of the door and then
present the card or press DOOR and enter the PIN at the touchpad.
If High Security mode is used, the card must be presented first and then
the PIN is entered on the touchpad.
DISPLAY ALARMS Press MEM.
DISPLAY TROUBLES
& SUPERVISORIES
Press STAT.
BYPASSING DOORS
To latch a door open or release the latch, press DOOR BYPS and then
present the card or enter the PIN on the touchpad. The touchpad will dis-
play “DOOR BYPASS” when doors are latched open. Doors remain
latched until they are manually unlatched.
4150 STATUS
To view the status of the analog inputs and relay outputs (controlled by the
Model 4150 Auxiliary Control), press 5 STAT. The analog inputs will be
shown on the touchpad display along with the programmed description. If
a 5260 printer is connected to the system (see Section 5.6 of this manual),
the status will also be printed.
TOGGLE X-10s
To toggle X-10 Modules on and off, press a number from 101-116 or
201-216, then * or CODE2 or DOOR, followed by 1 for ON and 0 for OFF.
Numbers 201-216 activate modules 1-16 from House Code 1. Numbers
from 201-216 activate modules 1-16 from House Code 2. The house
codes for each section are programmed into the EEPROM. The display
shows the actual house code and module address activated.
DISPLAY EVENTS
To display the event memory, press 1 MEM, then enter a START DATE to
begin the event display. Press the digits of the month, day, and year, then
press TEST. All events on or after this date will be shown. To show all the
events in memory, press CLR TEST.
CLEAR EVENTS
To clear the event memory, press 1 0 TEST and enter a code with Pro-
gram Mode access. Press 1 to erase the memory, 0 to quit, and press
TEST to continue.
ZONE DISPLAY
Press 1 STAT to display all zone locations assigned to the same areas as
the touchpad.
TOUCHPAD DISPLAY Press 2 STAT to view the touchpad location.
SOFTWARE REVI-
SION
Press 4 STAT to view the 4734 software date.