User guide

45
Regency Bellavista™ B36X Gas Fireplace
INSTALLATION
LOG SET INSTALLATION
Installation of Brick Panels must be completed before installing the log set.
Read the instructions below carefully and refer to the images. If the
logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can
alter the unit's performance which is not covered under warranty.
Log Kit #556-930 contains the following pieces:
A Rear Log
B Front Bottom Log
C Center Right Log
D Center Left Log
E Middle Left Log
F Front Left Log
902-156 Lava Rocks
902-179 Vermiculite
946-669 Platinum Embers
(supplied w/packaged manual)
1) Carefully remove the logs from the packaging and unwrap them. The
logs are fragile, handle with care - do not force into position.
2) Spread vermiculite along the base of the fi rebox.
Vermiculite
A
E
C
B
D
F
4) Place Log B on the front right side of the burner. Push the back of
the log against the 2 brackets with the notch on the bottom right side
of the log fi tting into the right side of the grate.
3) Place Log A on the rear log support pins with the fl at side to the
back.
A
Notch
B