Manual

Regency Bellavista™ B41XT Gas Fireplace

INSTALLATION

OPTIONAL FAN INSTALLATION

Important: 120 Volt AC power is needed for the fan switch and blower.

The receptacle box will be installed on the left hand side of the unit

and must be wired by a qualiﬁ ed electrician prior to fan

assembly being installed. The neutral(wider) slot of the polarized

receptacle should be at the top.

Ground terminal must not be removed.

Unit must be grounded at all times.

1) Turn the power off, unplug accent lights if installed.

2) Remove bottom louver if necessary. Remove the standard ﬂ ush

door.

3) Remove fan assembly from box, locate green ground wire and pull

out of fan assembly - taking care not to damage or cut wire casing.

4) Connect the Black wire to the left side terminal of the fan motor.

Slide the black wire and the green ground wire into grommet and

push grommet into the fan assembly housing.

5) Connect the Red wire onto the right side terminal of the fan motor,

Connect the red wire into the grommet and push grommet into the

fan assembly housing.

BLACK RED

6) Position the fan base with the motor end towards the rear of the

ﬁ rebox and then slide the fan in towards the rear of the unit. Turn

the fan housing slightly to the left and make the fan assembly paral-

lel to the rear wall.

7) Lift the fan housing upwards and slip it over the two mounting

studs. (use of dish soap will help the rubber grommets slide down

over the pins)

NOTE: If optional accent lights are installed,take care when sliding the

fan into position. Fan must be maneuvered around the right

side of the light.

8) Connect and secure fan ground cable to ground lug.