Manual

48
Regency Bellavista™ B41XT Gas Fireplace
INSTALLATION
1) Shut off electrical supply.
2) Remove Full Screen Door and bottom Louver if installed.
3) Remove the glass door - see instructions in manual.
4) Remove the logs, lava rock and vermiculite if installed.
5) Remove the brick or inner panels if installed - see instructions in manual.
6) Remove the burner and rear log tray - see below.
B41XT Accent Light Assembly Kit
1 910-814 Plug wiring + gasket
2 910-997 Halogen Bulb
2 940-363 Amber Glass
1 Light Assembly Includes gaskets (x 2)
1 918-864 Instruction Sheet
Important: 120 Volt AC power is required for the optional light.
The receptacle box will be installed on the lower left corner of
the unit and will need to be wired by a qualifi ed electrician prior
to the optional light installation. The neutral (wider) slot of the
polarized receptacle should be at the top. A wall mounted switch
should be installed to turn the accent lighting on/off.
See wiring diagram in the instruction manual.
Diagram 1: Remove the left and right screws.
Diagram 2: Slide burner assembly to the right
and then remove.
8) Remove the 2 screws securing the rear log tray and lift out. Diagram 3
Diagram 3
7) Slide the burner assembly to the right to release it from the orifi ce,
then lift it out.
10) Remove the 2 cover plates from the fl oor of the fi rebox by removing
2 screws from each plate.
11) Remove the cover plate and gasket from the underside of the fl oor of
the fi rebox.
12) Install gaskets onto light assembly mounting plates and feed wires
thru the underside of the fi rebox base. Left side shown, repeat for
right side.
9) Remove the 2 screws securing the base tray - lift base tray up and
out. Diagram 4a and 4b.
Diagram 4a
Diagram 4b
Base Tray
Firebox Base
OPTIONAL ACCENT LIGHT INSTALLATION