t

Regency
®
E18 Gas Fireplace Insert
37
INSTALLATION
5 1/4"
133mm
8 3/16"
208mm
2 1/8"
C
Firesong 220N Firebox
E18 Insert
Leg hei
g
5 - 3/16"
[132mm]
E18 INSTALLATION SPECIFICATIONS
See Installation of E18 into Existing Units for General Installation Guidance - for vent connection confi guration.
The length of 4" Flex needed is 6" semi-expanded.
Remove top fl ue adaptor from unit by removing 1 Philips screw and slide backward. Adjust fl ue adaptor length by resetting screw from Set 4 to Set 8 - see
Diagram below. Attach 4" fl ex to fl ue adaptor and insert into existing 5" vent - shown below.
Procedure to adjust the height of the outer fi rebox installed is shown below.
Right side shown
 
PP



PP

%
(3)LUHER[ (,QVHUW
'(7$,/%
6&$/(
$GDSWRU3ODWH
IDVWHQHUVHWWLQJ
)OH[$GDSWRU/HQJWK
&ROODU3ODWH6HWWLQJ9HQWSRVLWLRQ
1. Loosen 2 x Phillips screws on both right and left legs.
2. See above diagram below for required leg setting.
3 Install with supplied Phillips screws to pre-punched holes and tighten previous screws that were loosened in Step 1.
4. Keep left side leg loose until outer fi rebox is in position in ZC box - to allow adjustment of gas line.
See Step #2: Outer Shell installation for procedure.
FIRESONG 120N INSTALLATION SPECIFICATIONS
Set to this
hole
Set to this
hole
6"
(152mm)
Flue adaptor
setting
Secure vent slide plate to fl ex pipe with 4
screws
Firesong 120 fi rebox
Firesong 120 Firebox
6-1/8"
[156mm]
4-5/8"
[117mm]
1/2"
[13mm]