t

Regency
®
E18 Gas Fireplace Insert
41
INSTALLATION
REMOTE CONTROL INSTALLATION
Remote controls approved for use with this appliance:
Part # Remote Function
910-368 Basic Remote ON/OFF
910-399 Firegenie Remote ON/OFF + 7 day programmable
thermostat
946-680 GT Profl ame Remote ON/OFF + Thermostat control
NOTE: Remove bottom control panel on the surround prior to installing
the remote control.
1. S hut off gas and electrical supply, allow unit to cool to room temperature.
2. If using the GT Profl ame remote control, attach the wire labeled
receiver from the wiring harness to the back side of the remote
receiver. See Diagram 1 below.
Diagram 1
Diagram 4—cut female wire spade
Diagram 5
Diagram 6
Diagram 3 - Red TH wire disconnected
Diagram 2—Receiver in position
3. Install remote receiver (from any of the approved remote controls)
on the far right hand side of the unit. See Diagram 2 (Basic Remote
receiver shown).
4. Disconnect red wire from TH terminal on valve - see Diagram 3.
5. Cut the female wire spade from the disconnected red wire at the en
d
of connector see Diagram 4.
Bare the same red wire using wire strippers in order to connect ne
w
male connector, see Diagram 4.
5a. Crimp on new male connector wire using a crimping tool, see Diagram 5.
6a. Basic or FireGenie remote: Attach one of the two black wires fro
m
the remote receiver and connect it to the red wire disconnected i
n
the previous steps, see Diagram 5.
6b. GT remote control: Attach the white wire from the wiring harnes
s
labeled TP/TH and connect it to the red wire disconnected in th
e
previous steps, see Diagram 6.
Receiver wire harness
GT remote
Female wire spade
Strip wire—add male
connector
Receiver