t User guide

28
U32-5 FPI Direct Vent Gas Insert
INSTALLATION
OPTIONAL HEARTH TRIM
INSTALLATION
Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi replace is higher than the hearth or to raise the fi replace.
1) For units L390E/HZI390E/L540E/HZI540E–remove 4 screws in
locations shown below to remove outer faceplate.
1a) For units U31/U32/E21/E33–remove outer faceplate by lifting up
and off backing plate.
4) Secure hearth trim to backing plate with a clip on each side as
shown in Diagram 6. Ensure the hearth trim is evenly space on
either side of the backing plate.
5) Reinstall backing plate.
6) Reinstall outer faceplate.
**If no holes are present on the backing plate, proceed to the Step 3.
2) If screw holes are present on backing plate, secure the hearth trim
to backing place with 2 screws on each side.
** If no screw holes are present.
3) Remove backing plate by removing 4 screws–lay down fl at.
Diagram 1–Screw Locations
Diagram 2–Lift off Front Faceplate
Diagram 6–Hearth Trim Clip
Diagram 3–Hearth Trim Secured to Backing Plate
Diagram 5–Backing Plate Removal Units U31/U32/E21/E33
Diagram 4–Backing Plate Removal Units L390E/HZI390E/L540E/
HZI540E
Hearth Trim
Hearth Trim
Clip
LOW PROFILE HEARTH TRIM