Instruction Manual

20
Regency U31-3 Gas Fireplace Insert
INSTALLATION
1) Align the left side Faceplate Trim Bracket with the Firebox Flange
and secure using 2 screws as shown in diagram 1. Repeat for right
side.
Faceplate Trim
Bracket
Firebox
Flange
Blanking Plate
Flanges
3) Hold the Faceplate Trim up against the unit in order to make the
following wire connections.
Pull the ON/OFF connector wires from the fi rebox and connect
them to the switch.
Connect the fan switch wires with the wire connectors from the fan
speed control. Place clips over wires and tuck into side trim.
for gas
connection
Self-adhesive
wire clip
ON/OFF
switch
wires to
ON/OFF
switch
wires to
Fan switch
connectors
Fan Speed
Switch
(Rear View)
IMPORTANT NOTE:
When using the Surround, the unit must be set 1" further into the fi replace
than the standard faceplate installation. See the diagrams below for the
correct minimum fi replace opening requirements.
C
L
16”
21”
29”
f
EXCALIBUR SURROUND
INSTALLATION
2) Align the cut-outs in the Blanking Plate with the pins located on the
inside top of the fi rebox. Slide the Blanking Plate into position ensuring
it goes under the 2 fl anges.